Stripping stripping stage is a plastic injection molding cycle in the last link. While the products have been cold-forming, but the release is still a very important impact on the quality of products, stripping improper office supplies, it may result in product during stripping uneven force, cause deformation and other defects ejection. There are two main methods of stripping: stripping ejector and the stripper plate mold. To choose the right way to design mold releasing According structural characteristics of products to ensure product quality. For the selection of a mold releasing jack, the jack should be set as uniformly as possible, and the location should be selected in the release resistance and the largest local maximum strength and stiffness of plastic parts, so as not to damage the plastic deformation. The stripper plate is generally thin-walled containers for deep cavity and does not allow transparent products putter traces of mold release characteristics of this mechanism is that the release force and uniform, smooth movement production office supplies plastic shell, no significant The traces left. Injection injection molding injection molding, also known as injection molding, injection molding machine using rapid injection of molten plastic mold and cured to give a variety of plastic article. Almost all thermoplastics (except fluorine plastic) can use this method can also be used for some thermoset molding. Injection molded plastic parts production accounted for about 30%, it has a molded shape can be complex parts, size, accuracy, productivity advantages; but the high equipment and tooling costs, mainly for high-volume production of plastic parts. Commonly used injection molding machine with a plunger and screw type two office supplies high-quality suppliers, the right is a schematic view of the injection molding screw. Injection molding principle: when the powder and granular material from the hopper into the barrel, the plunger forward, material is pushed into the heating zone, and then after diversion shuttle, molten plastic through a nozzle into the mold cavity in the office supplies processors, namely the mold after cooling too plastic. Note plastic parts from the mold cavity is typically required for proper post-treatment after the removal, to eliminate the stress generated during molding of plastic parts, stable size and performance. In addition, removal of burrs and gate, polishing, surface finishing and so on. Office supplies shell processing _ integration into the plastic mold factory (certification) _ office supplies from Shenzhen harmony Technology Limited. Shenzhen harmony Technology Limited (www.rhctech.net) Guangdong Shenzhen, plastic products leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. The integration into a plastic mold factory leadership with the staff warmly welcome all inquiries negotiations to create harmony into a plastic mold manufacturers a better future.